You can find a “ready to use” image for an usb stick here(zip) or here(tar.gz).

Unpack the image on an USB-Stick (min. 100 MB) and edit flukso.conf to represent your own flukso.

To run the code simply plug your prepared USB-Stick to your chumby and restart the device.

The Chumby will now install the newest version of the chumby software. Please do not turn off the device during this procedure.

The device will restart during the update. This is normal and intended.

After the installation of the new software the touchscreen calibration will start. Follow the instructions on the screen to calibrate your touchscreen.

After calibration the Qt controlpanel starts. You are ready to go.

This software is not installed on your Chumby permanently. If you want the original interface back just remove the USB-Stick and restart your Chumby.