This is an old revision of the document!
The Flukso USB development board is a small PCB, intended for development work. It reproduces all features of the Flukso sensor board, but has an FTDI USB-serial chip. It can be connected to any USB port.
If you want to use a current clamp with the board: We use an J&D Electronics Split Core Transducer (50 A - 0-5V), Model no. JC10F50-V.
The software port and hardware reference is on github: https://github.com/comsound/flukso. You can clone a local copy of the repository using
git clone https://github.com/comsound/flukso.git
You need to be able to solder SMD components, I am using the “solder wick” method here (google is your friend). The components are fairly easy to mount. Start with the FTDI and ATMega644 components, then continue with the resistors and capacitors, then the crystal and the large cap, finally install pinheaders and the USB connector.
The layout of the board is fairly simple:
Please be careful regarding the orientation of the LEDs, the GND side is on the left in the picture above. See also.
A highres image for your reference: (yes, I know, the yellow LED is missing in action.)
The repository contains a folder “software” with an adjusted version of the Flukso firmware for this board. Mainly, the clock speed has been changed and additional adjustments to accomodate the ATMega644, since the original Flukso sensor boards are using an ATMega48.
The firmware can be built by typing “make”. Please note that you might need to adjust the path to your AVR-GCC installation. The “make upload” target programs the ATMega, including setting the fuses (which needs to be done only once - the Makefile can be adjusted).
I use an USBasp programmer which I highly recommend. Since the fuses are not set initially, you need to set the SCK jumper (or use avrdude's -B 3 option). I also power the board over the programmer during programming. Please note the orientation of the 6pin ISP header:
If everything went well, you should be able to see something like this on a serial console (via the USB port):
$ screen /dev/cu.usbserial-A800ftEn 4800 pwr 0123456789abcdef0123456789abcde0:0000000000 pwr 0123456789abcdef0123456789abcde1:0000000000 pwr 0123456789abcdef0123456789abcde0:0000000000 pwr 0123456789abcdef0123456789abcde1:0000000000
Each second, a new pair of lines should appear - even without an attached sensor.
Congratulations, and happy hacking!
What are the LEDs for?
What inputs are there?