User Tools

Site Tools


fluksousbboard

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

fluksousbboard [2011/02/15 16:59]
gonium
fluksousbboard [2012/10/30 10:27] (current)
Line 37: Line 37:
 programs the ATMega, including setting the fuses (which needs to be done only once - the Makefile can be adjusted). programs the ATMega, including setting the fuses (which needs to be done only once - the Makefile can be adjusted).
  
-I use an [[http://www.fischl.de/usbasp/|USBasp programmer] which I highly recommend. Since the fuses are not set initially, you need to set the SCK jumper (or use avrdude's -B 3 option). I also power the board over the programmer during programming. Please note the orientation of the 6pin ISP header:+I use an [[http://www.fischl.de/usbasp/|USBasp programmer]] which I highly recommend. Since the fuses are not set initially, you need to set the SCK jumper (or use avrdude's -B 3 option). I also power the board over the programmer during programming. Please note the orientation of the 6pin ISP header:
  
 {{:img_1439.jpg|}} {{:img_1439.jpg|}}
Line 54: Line 54:
  
  
 +====== More hints ======
  
 +What are the LEDs for?
 +  * red: operation
 +  * blue: tx for FTDI
 +  * yellow: rx for FTDI
 +  * green: signal an incoming S0 pluse or "writing to eeprom has finished" (see [[https://github.com/comsound/flukso/blob/master/software/main.c#L160|remark]] in source)
 +
 +What inputs are there?
 +  * INPUT0: analog input for one split core transducer mentioned above
 +  * INPUT1: analog input for three split core transducers in series
 +  * INPUT2 + INPUT3 + INPUT4: S0 inputs
 +
 +What about a case?
 +  * The board fits nice into a TEKO A2 case, cutouts for the conectors can be made by cutting two slots into the cover on each side, then the remaining metal is bend to the inner, leaving a stable structure.
fluksousbboard.1297785547.txt.gz ยท Last modified: 2012/10/30 10:36 (external edit)