This is an old revision of the document!
The Flukso USB development board is a small PCB, intended for development work. It reproduces all features of the Flukso sensor board, but has an FTDI USB-serial chip. It can be connected to any USB port. The software port and hardware reference is on github: https://github.com/comsound/flukso
git clone https://github.com/comsound/flukso.git
You need to be able to solder SMD components, I am using the “solder wick” method here (google is your friend). The components are fairly easy to mount. Start with the FTDI and ATMega644 components, then continue with the resistors and capacitors, then the crystal and the large cap, finally install pinheaders and the USB connector.
The layout of